topic Archicad 27 3D modelling in Modeling

Archicad 27 3D modelling

ESK — Tue, 14 Nov 2023 12:05:02 GMT

At our studio we had a major problem in Archicad 27. When modelling in 3D, no geometry edits were shown in the 3d window.
New geometry not visible in 3d window, modifications in geometry was not showing, deleted geometry was still shown. The edits in geometry became visible when closing the 3D window and opening it again from plan view. Same for hiding and showing the layer. The reoccuring problem in Archicad 27 is shown in the video below.

Solution:

The solution is to pin and unpin some geometry to a Renovation Filter.

Re: Archicad 27 3D modelling

Christophe Fortineau — Tue, 14 Nov 2023 12:55:07 GMT

Hello @ESK,

It is probably not a bug 😉

You should to unlock 3D Cutting Planes.

Re: Archicad 27 3D modelling

Laszlo Nagy — Wed, 15 Nov 2023 11:50:46 GMT

ESK,

You should put your system configuration in your signatures, it would make it easier to help you.

There are similar issues for users on Intel-based Mac with AMD cards? Do you have that configuration?

https://community.graphisoft.com/t5/Installation-update/Graphics-issues-that-happen-on-AC-27-in-Mac/m-p/574306#M36038

https://community.graphisoft.com/t5/Installation-update/AC27-IntelMacs-3D-view-causes-the-freezing-of-all-views/m-p/401470#M35752

In this thread, there is a workaround offered that might help:

https://community.graphisoft.com/t5/Installation-update/Archicad-27-doesn-t-work-on-Intel-based-iMac-with-AMD-graphics/m-p/401783#M35787

Re: Archicad 27 3D modelling

ESK — Thu, 16 Nov 2023 09:06:04 GMT

Hi Lazslo

Thanks for reaching out. I have updated my signature.

Re: Archicad 27 3D modelling

ESK — Thu, 16 Nov 2023 09:48:10 GMT

Hi Christophe

Thanks for suggesting a solution. Disabling 3D cutting planes didn't make a difference in this case.

Re: Archicad 27 3D modelling

Christophe Fortineau — Thu, 16 Nov 2023 09:51:04 GMT

Hello ESK,

Are you able to share a mod file about your project ?

Re: Archicad 27 3D modelling

ESK — Thu, 16 Nov 2023 11:46:52 GMT

Hi Christophe

My own solution works fine, I just wanted to share the information in the forum. I'm not allowed to send a file containing our company standard template. Thanks for offering your help.