topic Re: Wall segment dissapeared in Modeling

Wall segment dissapeared

PTLilla — Tue, 07 May 2024 20:38:37 GMT

The attached complex wall profile if used as a wall doesn't appear in full width. If I delete part of the wall that looks in top view as intended, the missing part appears. When used as a beam it looks as it should. The top view is set to show all lines, the two parts are mirrored from each other and are totally the same.

Operating system used: Windows

Re: Wall segment dissapeared

Patrick M — Fri, 03 May 2024 18:18:27 GMT

what is the projection setting of the wall? complex profiles on walls don't always give a full range of options you'd like to see. Sometimes you have to fuss with the projection settings and the floor plan cut plane.
without seeing what the actual geometry is and the actual wall/profile settings, it's hard to say what is going on with the plan view. But I'd start by setting the wall to "projected with overhead", then play with the floor plan cut plane to get it to show cut where you want it.

Re: Wall segment dissapeared

PTLilla — Tue, 07 May 2024 07:09:01 GMT

Tanks, but we tried that. The main problem is that the wall profile is a mirorred thing with two identical part, and just one part looks as it should. If i delete a portion of the other half, it appears again.

Re: Wall segment dissapeared

Laszlo Nagy — Tue, 07 May 2024 21:00:18 GMT

You could also check for Walls on hidden Layers. They may intersect your visible Wall resulting in the above behavior.

Make all layers visible, and see if there are any "naughty" Walls.

Re: Wall segment dissapeared

Lingwisyer — Wed, 08 May 2024 01:25:34 GMT

Overlapping reference lines?