topic Wall tool _ issue: "45 degrees cuts" for the bottom edges of the walls in Modeling

Wall tool _ issue: "45 degrees cuts" for the bottom edges of the walls

tecsa — Mon, 18 Nov 2024 14:24:08 GMT

Hello everyone,

I'm recently facing the following "anomaly": the walls are having 45 degrees cuts at the bottom edges like in the bellow picture.

Can anybody tell me why? can anybody advise how to have normal edges (90 degrees edge) for the bottom edges of the walls?

PS: I'm using Archicad 21 (with usb key) if it counts.

Thank you!

Rares

Operating system used: Windows Windows 10 Enterprise

Re: Wall tool _ issue: "45 degrees cuts" for the bottom edges of the walls

cuba — Mon, 18 Nov 2024 19:26:13 GMT

This is not normal, does this happen to all your walls?

It looks like a complex profile wall with bevelled edges. Can you send more screenshots/infomation? walltype etc..

Re: Wall tool _ issue: "45 degrees cuts" for the bottom edges of the walls

tecsa — Mon, 18 Nov 2024 21:21:50 GMT

Yes, I noticed this issue for all the walls, independent on which level I'm creating the wall.

I didn't use complex profile walls.

The beveled edges are visible also on facades at the junction line between the levels of the building. Each time, the bottom edges of each wall are beveled (snips bellow) ...

Snip with basic section wall:

Snip from 1st level, having a composite section wall:

Re: Wall tool _ issue: "45 degrees cuts" for the bottom edges of the walls

Jeff Thompson — Tue, 19 Nov 2024 02:16:24 GMT

Can you provide a snapshot of your wall properties?

Re: Wall tool _ issue: "45 degrees cuts" for the bottom edges of the walls

tecsa — Tue, 19 Nov 2024 09:03:05 GMT

pls see bellow @Jeff Thompson

Re: Wall tool _ issue: "45 degrees cuts" for the bottom edges of the walls

Jeff Thompson — Tue, 19 Nov 2024 17:51:12 GMT

Okay I may have found your problem. I think you've somehow turned on the Log Wall properties for all your walls. Take a look at my two images and let me know if you've got the Log Wall properties turned on (checked). If you turn it off the 45 deg angles should go away. This was the only way, beside a complex profile, that I could replicate your problem. Let me know your results.

Re: Wall tool _ issue: "45 degrees cuts" for the bottom edges of the walls

tecsa — Tue, 19 Nov 2024 18:13:02 GMT

Hei Jeff

this was the issue 🙂

Thank you so much!

All the best!

Rares