topic Re: HCTPBWIW? [Railing Tool] in Modeling

HCTPBWIW? [Railing Tool]

Patrick M — Thu, 23 Jan 2025 19:24:50 GMT

This tool continues to hit the wall on its limits in very basic conditions.

Operating system used: Mac Apple Silicon

Re: HCTPBWIW? [Railing Tool]

Lingwisyer — Tue, 28 Jan 2025 08:21:13 GMT

Are these part of the Rail Connection?

Wonder when rail arrays will be implimented... the wish no longer seems to exist...

Re: HCTPBWIW? [Railing Tool]

Patrick M — Tue, 04 Feb 2025 22:11:23 GMT

it is a connection issue. I just had to kick it around 5-6x and it eventually cleaned up. this was done with a single rail, using a complex profile

Re: HCTPBWIW? [Railing Tool]

Barry Kelly — Wed, 05 Feb 2025 00:28:00 GMT

Separated rails will clean up automatically.

I can't say I have tried with a single complex profile rail.

Barry.

Re: HCTPBWIW? [Railing Tool]

Lingwisyer — Wed, 05 Feb 2025 01:37:20 GMT

Ah, yeah, your issue stems from the (profile_height)cos(slope_angle) of your "rail" being longer than the gap between your posts. It creates a single fillet at the mid point, and that just so happens to extend beyond your post. If you extended the distance between the top of your stair and the corner you should notice that it will clean up properly.

Ling.

ps. Rail Arrays when?

pss. I cannot seem to find the wish...