topic Re: Wall End - cut outline error in Modeling

Wall End - cut outline error

Zendrix — Fri, 28 Feb 2025 21:46:26 GMT

Hi!

Im having an issue with a wall end in a simple composite wall made of plaster/brick/plaster. As you see in the pictures, the line thickness (exterior contour) is interrupted at some point in this wall end. Im not sure what i am doing wrong.

Thanks,

Re: Wall End - cut outline error

Lingwisyer — Thu, 27 Feb 2025 01:27:57 GMT

Would it not be better to use the Wrapped End type instead?

Re: Wall End - cut outline error

Zendrix — Fri, 28 Feb 2025 21:47:01 GMT

Thank you Lingwisyer, that was it. I have another problem now, though, which is that i cant make only the exterior line thicker, when i choose a thickness, it applies it to both the outline cutline and the interior brick line ending.

is there any way to make that happen?

Thank u!

Re: Wall End - cut outline error

Lingwisyer — Fri, 28 Feb 2025 01:09:56 GMT

Unless you are wanting it to use different Pens to the rest of your wall, you should just be checking the toggle "Use Wall's Contour Pen" ("Usar a Caneta de Contorno da Parede" I would assume), then it will just use the Pens matching your Composite.

Ling.

Re: Wall End - cut outline error

Zendrix — Fri, 28 Feb 2025 21:47:32 GMT

I tried that before, but it uses a grey pen on the brick, i dont know why...

Thanks

Re: Wall End - cut outline error

Lingwisyer — Sun, 02 Mar 2025 09:00:49 GMT

Do you have Wall End Lines turned on for the brick layer of your Composite?

Re: Wall End - cut outline error

Zendrix — Mon, 03 Mar 2025 14:54:45 GMT

That was it Lingwisyer, my composite had the brick with a greyish line for the wall end.

Thank you very much!