topic Re: Complex profile skin in Modeling

Complex profile skin

Guillermo1 — Tue, 04 Mar 2025 18:00:25 GMT

Hello , Why the door dont cut one of the skins of a complex profile wall?

Operating system used: Mac Intel-based

Re: Complex profile skin

Florin Luca — Tue, 04 Mar 2025 18:58:25 GMT

Check this thread out, it might have the answer you’re looking for:

https://community.graphisoft.com/t5/Modeling/Complex-Profile-Opening-Reference-Line-issue/m-p/401859#M168758

Re: Complex profile skin

Guillermo1 — Tue, 04 Mar 2025 19:45:58 GMT

i think there is no solution to my question in that thread

Re: Complex profile skin

Florin Luca — Tue, 04 Mar 2025 20:01:06 GMT

Did you check the position of the Opening References in your complex profile? I suspected (hence the link) that one of the references is located on the outside face of one skin but not on the other, and bc of that, the door doesn’t cut through the latter. If that were the case, all you’d have to do is move one of the opening references to the correct position. But maybe I’m wrong:)

Re: Complex profile skin

Guillermo1 — Wed, 05 Mar 2025 11:18:39 GMT

i have to check it in the complex profile?

Re: Complex profile skin

Barry Kelly — Thu, 06 Mar 2025 01:28:25 GMT

If you are referring to the green lines going through the door space, is your door sill above the base of the wall?

That is normal to see the wall sides in that case.

Barry.

Re: Complex profile skin

Guillermo1 — Fri, 07 Mar 2025 18:05:28 GMT

there are fills also that the door dont cut in the wall socket