topic Re: Window Reveal in Composite Wall Graphics in Modeling

Window Reveal in Composite Wall Graphics

jd10003 — Sat, 03 Jan 2026 01:36:42 GMT

I have two questions about the return on a window reveal in a composite wall. (I'm attaching a screenshot below.)

1. Can I have two composite skins return into the window reveal? I'd like my stucco (green) AND my waterproof membrane (cyan) to wrap into the opening. (I have a workaround for how I'd actually construct this, but it will be a pain to model!)

2. I've got the composite skin ends turned on so that everything joins up properly, but that means it gives me a little "tail" where the stucco returns into the window reveal. Any way to turn off that little green nub??

Hopefully you folks have an easy answer!!

Re: Window Reveal in Composite Wall Graphics

CosminF — Mon, 05 Jan 2026 21:14:35 GMT

Hi,

Have you tried fiddling around with the settings for the wall closure ->

If I understood your question correctly, you can achieve your desired turn-in by adjusting those parameters.

Re: Window Reveal in Composite Wall Graphics

jd10003 — Sat, 03 Jan 2026 19:20:50 GMT

Ok yes thank you. I didn't realize it was a two-step process....select the skin from that drop down and then adjust its parameters separately. Got it. Thank you!

(Any ideas about changing that skin end line though??)