topic Re: HOW DO I REMOVE ARTIFACTS FROM MODEL in Modeling

HOW DO I REMOVE ARTIFACTS FROM MODEL

Eric Milberger — Mon, 18 May 2026 13:52:34 GMT

How do I remove the artifacts or merge these cabinets into one. It needs to be clean for presentation. NO ARTIFACTS

Operating system used: Windows 11 pro

Re: HOW DO I REMOVE ARTIFACTS FROM MODEL

Lingwisyer — Mon, 18 May 2026 02:04:06 GMT

In 3D, you can do a Solid Element Operation to Subtract one from the other. This will not fix your 2D though... You also appear to have an offset to the rear of your counter which will not align through the corner... Though you have tagged this post as Composites? Have you considered just modelling it as basic walls and / or slabs?

Ling.

Re: HOW DO I REMOVE ARTIFACTS FROM MODEL

cuba — Mon, 18 May 2026 07:17:54 GMT

Make a complex profile of the shape (section) and draw it like a wall or beam. No artifacts

Re: HOW DO I REMOVE ARTIFACTS FROM MODEL

Lingwisyer — Tue, 19 May 2026 02:09:12 GMT

The issue with CPs is that you need a additional end cappings and spacers if you are not wall to wall or need divisions respectively. Great for something quick though.

Ling.

Re: HOW DO I REMOVE ARTIFACTS FROM MODEL

Barry Kelly — Tue, 19 May 2026 11:31:59 GMT

If they are actual Graphisoft cabinet objects, you can place corner cabinets and set the desired angle.

I do not use these objects, so can't say if they are any good or not or which one is best to use.

Barry.

Re: HOW DO I REMOVE ARTIFACTS FROM MODEL

JeffH — Tue, 19 May 2026 14:27:42 GMT

You could always turn the counter off for your cabinets, and draw that as a slab, on the same layer