https://community.graphisoft.com/t5/Modeling/Trouble-plotting-a-file/m-p/704527#M179667 <P>Having a problem. When I open a file to print, it's fine. But when I go to print it, one of the walls gets screwed up as shown in the attached. What could cause this?</P> Fri, 05 Jun 2026 15:54:54 GMT mukster 2026-06-05T15:54:54Z https://community.graphisoft.com/t5/Modeling/Trouble-plotting-a-file/m-p/704527#M179667 <P>Having a problem. When I open a file to print, it's fine. But when I go to print it, one of the walls gets screwed up as shown in the attached. What could cause this?</P> Fri, 05 Jun 2026 15:54:54 GMT https://community.graphisoft.com/t5/Modeling/Trouble-plotting-a-file/m-p/704527#M179667 mukster 2026-06-05T15:54:54Z https://community.graphisoft.com/t5/Modeling/Trouble-plotting-a-file/m-p/704566#M179679 <P>What is it suppose to look like? What I assume are walls all look the same in your pdf...</P> <P>&nbsp;</P> <P>ps. Oh, are those wall elevations? Are you talking about the vectorial hatching on the top left?</P> Mon, 08 Jun 2026 01:57:32 GMT https://community.graphisoft.com/t5/Modeling/Trouble-plotting-a-file/m-p/704566#M179679 Lingwisyer 2026-06-08T01:57:32Z