topic Issue was deleted and canno show the image but Dimention of a dimension reads differently in Modeling

Issue was deleted and canno show the image but Dimention of a dimension reads differently

Eric Milberger — Sun, 14 Jun 2026 15:05:11 GMT

I placed a picture

Scaled that drawing and measured with a dimension. overall down the image and ALL was Good

Then I measured the measurement and the new measurement of the measurement never the image

And the measurements are totally different.

Note did not measure the image btue measured a measurement and the distances did not equal/

Re: Issue was deleted and canno show the image but Dimention of a dimension reads differently

Barry Kelly — Mon, 15 Jun 2026 00:41:20 GMT

Can you post a screen shot?

I can't quite follow what you are doing.

Did you use the 'figure' tool to place a picture or the 'drawing' tool to place a drawing?

Are you saying, you have measured the dimension, but the measurement does not show what the dimension says?

Barry.

Re: Issue was deleted and canno show the image but Dimention of a dimension reads differently

Lingwisyer — Mon, 15 Jun 2026 01:20:57 GMT

How different are we talking? More than just having different Dimension Settings vs Working Units?

Re: Issue was deleted and canno show the image but Dimention of a dimension reads differently

Eric Milberger — Tue, 16 Jun 2026 13:44:18 GMT

Is that not enough? I will repost as I get re engaged today.

Re: Issue was deleted and canno show the image but Dimention of a dimension reads differently

Barry Kelly — Wed, 17 Jun 2026 06:44:05 GMT

I don't understand what you mean by you "measured a measurement".

Do you mean you use the measurement tool to measure the length of a placed dimension?

An image will explain a lot (I hope).

Barry.

Re: Issue was deleted and canno show the image but Dimention of a dimension reads differently

Patrick M — Thu, 18 Jun 2026 20:41:17 GMT

it sounds like either your dimension style (option > project preferences > dimension) is rounding or your working units (options > project preferences > working units) are rounding... maybe both?
...
i set both to 1/64" precision in my templates. I hate seeing 10'+10'-1/4" = 20' - 1/2". I also hate looking at the tracker and seeing anything but the actual number input. I don't personally click, I input the value/distance in the tracker, but I also don't want the measure tool (also uses tracker) to round up/down.