Injecting to object in library view in AC 28 SPA works different than previously

Ignacio Azpiazu — Wed, 19 Aug 2026 02:34:09 GMT

I just noticed this in just-installed latest AC 28 SPA; I had not noticed it in other 28s or 29s, but didn't verify now:

- historically you selected a say window, syringe-extract, pick some other window in the library view and syringe-inject, and it worked;

- in latest just-installed-and-updated 27 SPA the A (width) dimension, not sure about other parameters, won't transfer in syringe-inject in library folder view unless after syringe-extract you deselect the window, select it again, and then open settings to look up the other window. Took me a while.

Re: Injecting to object in library view in AC 28 SPA works different than previously

Barry Kelly — Wed, 19 Aug 2026 03:25:13 GMT

Check the 'Element Transfer Setting' that you are using.

These can be set not to transfer particular parameters.

Door & window size is one of them.

Barry.

topic Injecting to object in library view in AC 28 SPA works different than previously in Modeling

Injecting to object in library view in AC 28 SPA works different than previously

Re: Injecting to object in library view in AC 28 SPA works different than previously