topic Re: Arch openings problem in Modeling

Arch openings problem

Anonymous — Thu, 25 May 2023 16:18:55 GMT

I have a problem using the arch-window opening
The default arch-window use a semi-circle as an arch but this ,if the window is to long,make the window higher than the host wall.
I also try the ellipse window but i have the same problem
Is there an arch-window that use an arch smaller than the semi-circle of the standard window
Thanx

Re: Arch openings problem

Anonymous — Wed, 22 Mar 2006 00:15:32 GMT

Do you mean like this, in Door and Window Builder, where the arch is not tangential at the sides?

Re: Arch openings problem

Anonymous — Wed, 22 Mar 2006 08:16:07 GMT

Yes ,this is ,but a don't have window door builder what can i do???

Re: Arch openings problem

Anonymous — Wed, 22 Mar 2006 22:10:10 GMT

Miker here is a Screen Shot I had saved for a Different Post back in Dec. 2005. W Eyebrow Fix.

Also Check out this Post, also.

Note: I do not recommend the SE Library.

Re: Arch openings problem

Anonymous — Thu, 23 Mar 2006 13:07:34 GMT

Thanks for the replies but i want an empty opening and not a window.

Re: Arch openings problem

Scott Bulmer — Thu, 23 Mar 2006 13:59:55 GMT

Miker,
You most likely already know this, but use SEO for a hole or if you need an empty opening with a frame make a custom window easily done in AC9. Hope that's what you're looking for.
Scott

Re: Arch openings problem

Anonymous — Thu, 23 Mar 2006 17:08:50 GMT

If i don't find anything else i 'll do it the easy way.
Thanks anyway

Re: Arch openings problem

Djordje — Fri, 24 Mar 2006 07:07:37 GMT

miker wrote:
Thanks for the replies but i want an empty opening and not a window.

Draw the slab of the required shape, set its ID to wallhole, save as a window.

Re: Arch openings problem

Scott Bulmer — Fri, 24 Mar 2006 14:06:41 GMT

Djordje wrote:

Draw the slab of the required shape, set its ID to wallhole, save as a window.

Thanks Djordje; that info is huge!
S

Re: Arch openings problem

Anonymous — Fri, 24 Mar 2006 23:09:02 GMT

Scott wrote:
Djordje wrote:
Draw the slab of the required shape, set its ID to wallhole, save as a window.
Thanks Djordje; that info is huge!
S

Additionaly you can use as ID the "Wallniche"
It cut a piece from a wall not a through out hole