topic Trim and jamb/head surfaces for an empty opening? in Modeling

Trim and jamb/head surfaces for an empty opening?

Anonymous — Thu, 25 May 2023 16:18:51 GMT

Is it possible to add trim to an empty opening so that it can match the adjacent doors and windows? Am I missing that library part?

Re: Trim and jamb/head surfaces for an empty opening?

Anonymous — Fri, 31 Mar 2006 02:41:57 GMT

Jesse,
You might try carefully checking the parameters of AC 9's
door library to see if there is a parameter
that hides the door panel leaving a jam and trimmed opening.
In an earlier library version this was an option for some doors.
I say carefully because, as I recall, the door part that had this
option hid this option in the parameter list by making the
parameter for "door panel thickness" have the option of making
the thickness=zero which would cause the door panel not to be drawn.
Peter Devlin

Re: Trim and jamb/head surfaces for an empty opening?

Anonymous — Fri, 31 Mar 2006 03:25:53 GMT

Jesse,
I just looked at one of the interior doors in the AC 9 library
and it has the option your looking for in the "Panel" settings
pull out menu item "Empty". Probably any door or window
has this option.
Peter Devlin

Re: Trim and jamb/head surfaces for an empty opening?

__archiben — Sun, 02 Apr 2006 02:39:02 GMT

Peter wrote:
You might try carefully checking the parameters of AC 9's door library to see if there is a parameter that hides the door panel leaving a jam and trimmed opening.

there is. use the same door as the one next to it and switch off the leaf/panel . . .

~/archiben

Re: Trim and jamb/head surfaces for an empty opening?

Anonymous — Sat, 08 Apr 2006 02:21:53 GMT

THANKS!