topic Re: Magic Wand and Meshtool +elevations in Modeling

Magic Wand and Meshtool +elevations

Anonymous — Tue, 19 Dec 2006 09:53:49 GMT

I'm trying to make different elevations from a DWG drawing using the meshtool and the magic wand. But I can't get a smooth transition between the different heights, without manually changing every point. Is the someway to change this in the settings, or do I need a Add-On to sort this out?
________
Wicca forum

Re: Magic Wand and Meshtool +elevations

Anonymous — Tue, 19 Dec 2006 11:08:22 GMT

there is an easier way to do that thing you want.
you need to bult with your magic wand the whole mesh, the bigger piece. then with this mesh selected and with your mesh tool from the toolbar selected you click magic wand and then every line from your mesh (See the pictures) and then you can select only these lines to elevate mesh points clicking apply to all.

Re: Magic Wand and Meshtool +elevations

Anonymous — Tue, 19 Dec 2006 11:09:17 GMT

then you add the new points and then you elevate them

Re: Magic Wand and Meshtool +elevations

Anonymous — Tue, 19 Dec 2006 11:13:16 GMT

and then you must select only the new points (this you can do it by clicking not on a grip but on an edge) and then click the mesh tool and then the grip to see the pet pallette to click the elevate mesh point and click the apply to all.

i hope you can understant from all these

Re: Magic Wand and Meshtool +elevations

Djordje — Tue, 19 Dec 2006 15:52:17 GMT

http://archicad-talk.graphisoft.com/viewtopic.php?t=13929

Exactly the same topic, with lots of discussion. Search and read first, write later.

Vivi, great screen shots!

Re: Magic Wand and Meshtool +elevations

Anonymous — Tue, 19 Dec 2006 20:02:24 GMT

Thanks Djordje 🙂

Re: Magic Wand and Meshtool +elevations

Anonymous — Wed, 20 Dec 2006 17:56:59 GMT

Thanks WENDY_NEVERLAND

After a while a figured the whole thing out!

I'll keep that in mind to next time Djordje
________
Marijuana Seeds