topic Re: material not showing in layout in Modeling

material not showing in layout

Anonymous — Thu, 25 May 2023 15:53:22 GMT

here is a pic ture of elevation view and the layout. Notice the 2nd floor slab which has 6" siding in elevation but in the Layout it is not showing up?

Re: material not showing in layout

Anonymous — Fri, 28 Mar 2008 15:26:31 GMT

here is the layout

Re: material not showing in layout

Anonymous — Tue, 01 Apr 2008 15:29:30 GMT

no ideas?

Re: material not showing in layout

Thomas Holm — Tue, 01 Apr 2008 22:46:17 GMT

shrink slab so it doesn't show. Use one two-storey-high wall instead of the ones you've got.

Re: material not showing in layout

Anonymous — Tue, 01 Apr 2008 23:12:11 GMT

Are you sure it is the same material to the slab edge as the wall above?

I'm also wondering why the marked distant area shows on one but not the other? I thought they were the same view? I'm not sure why that might affect the display of a material fill though.

Check the Model view options too, I'm not sure if the options for fills have an effect in elevation or not. Might be worth checking?

Re: material not showing in layout

Anonymous — Thu, 10 Apr 2008 17:59:02 GMT

yes it is the same material, the distant area is like that due to true line weight differences. I ended up just using a fill. I could not figure it out, all the other elevations were showing it fine.

Re: material not showing in layout

Djordje — Fri, 11 Apr 2008 12:48:21 GMT

I would check the settings of both the views again.

If all else fails, set everything as it should be manually, select the proper view, open the settings, and Set to current window - that would correct any discrepancy that you might have forgotten to set.