https://community.graphisoft.com/t5/Modeling/Working-with-the-Mesh-Tool/m-p/61161#M30889 <DIV class="actalk-migrated-content"><T>I have recently began exploring the capabilities of the Mesh tool. I have been successful in building a sloped stepped site, but is there a way to manipulate the mesh points so that the site has a more realistic slope and not stepped. I have tried to simulate this in the "Regular Sloped Mesh" option too,but it gives a straight slope, like the roof tool, no gradual bumps and so on. Please advise???</T></DIV> Tue, 23 May 2023 13:30:18 GMT Anonymous 2023-05-23T13:30:18Z https://community.graphisoft.com/t5/Modeling/Working-with-the-Mesh-Tool/m-p/61161#M30889 <DIV class="actalk-migrated-content"><T>I have recently began exploring the capabilities of the Mesh tool. I have been successful in building a sloped stepped site, but is there a way to manipulate the mesh points so that the site has a more realistic slope and not stepped. I have tried to simulate this in the "Regular Sloped Mesh" option too,but it gives a straight slope, like the roof tool, no gradual bumps and so on. Please advise???</T></DIV> Tue, 23 May 2023 13:30:18 GMT https://community.graphisoft.com/t5/Modeling/Working-with-the-Mesh-Tool/m-p/61161#M30889 Anonymous 2023-05-23T13:30:18Z https://community.graphisoft.com/t5/Modeling/Working-with-the-Mesh-Tool/m-p/61162#M30890 Your post is puzzling to me.<BR /> I have some questions that, if you don't mind, I would like<BR /> you to answer so that I might help you.<BR /> <BR /> What is the "Regular Sloped Mesh" option ?<BR /> I am not familiar with this. Do you mean polygonal geometry<BR /> method as opposed to the regular grid or do you mean<BR /> solid mesh versus surface with skirt or surface only ?<BR /> These are the only options I know of for the mesh tool.<BR /> <BR /> You say that you have successfully built "a sloped stepped site".<BR /> Do you mean that, using the mesh tool (not the slab tool),<BR /> you have made a mesh that has sharply defined steps as<BR /> opposed to a slope defined by contour lines ?<BR /> <BR /> If that is what you mean then that is a most difficult thing<BR /> to do with the mesh tool because you would have to<BR /> make pairs of contours very close together and assign<BR /> an elevation to one of them that was significantly different<BR /> than the other for each pair of contours.<BR /> <BR /> It is hard for me to believe you have done this so<BR /> I need more information about how you have built your mesh.<BR /> <BR /> Thank you,<BR /> Peter Devlin Mon, 17 Apr 2006 19:41:18 GMT https://community.graphisoft.com/t5/Modeling/Working-with-the-Mesh-Tool/m-p/61162#M30890 Anonymous 2006-04-17T19:41:18Z