topic Re: Create Stair using Selection - 900mm run length in Modeling

Create Stair using Selection - 900mm run length

Anonymous — Thu, 25 May 2023 15:04:52 GMT

Can anyone help? I need to make a stair from a selection. However, the minimum depth (from base of stair to top of stair measuring the goers in total - stair run) which Archicad can cope with is 1200mm. I need to make a stair with a run of 900mm with the stair being a trapezoid.

Cheers

Baz

Re: Create Stair using Selection - 900mm run length

Djordje — Fri, 02 Jul 2004 17:16:23 GMT

Baz wrote:
Can anyone help? I need to make a stair from a selection. However, the minimum depth (from base of stair to top of stair measuring the goers in total - stair run) which Archicad can cope with is 1200mm. I need to make a stair with a run of 900mm with the stair being a trapezoid.

Can you post the screenshot of the PlotMaker settings?

I am guessing your riser to tread ratio does not allow for a shorter stair.

I have been doing steps 300mm "high" but you have to tell PlotMaker to allow you to do it! 😉

Re: Create Stair using Selection - 900mm run length

Anonymous — Fri, 02 Jul 2004 19:48:43 GMT

Djordje,

You mean StairMaker I presume. Unless you know some PlotMaker tricks for building stairs

Re: Create Stair using Selection - 900mm run length

Djordje — Fri, 02 Jul 2004 20:32:27 GMT

Matthew wrote:
Djordje,

You mean StairMaker I presume. Unless you know some PlotMaker tricks for building stairs

Ouch!

Of course I do!

This is what catching up with two weeks' worth of ArchiTalk does to you ...