topic Re: curved roof and cadimage roof builder in Modeling

curved roof and cadimage roof builder

Anonymous — Tue, 23 May 2023 13:15:29 GMT

I've curved roof built by 'mesh to roof' . 'the mesh to roof' generate that roof become segmented. is it possible if i draw curved roof not in segmented (one part curved roof)?

then i'll using cadimage roof builder so my curved roof have looks like simple roof as image i attached.

thanks

Re: curved roof and cadimage roof builder

Djordje — Sat, 03 Nov 2007 16:52:00 GMT

Not as a roof.

You can use the Profiler, or a Custom profile wall or a beam.

Re: curved roof and cadimage roof builder

Karl Ottenstein — Sat, 03 Nov 2007 17:02:33 GMT

Also not as a roof - but it appears that the curve on one side is different than the curve on the other. The complex profiles cannot create such an extrusion - however Cigraph's ArchiForma can, and I suspect that Objective and Cadimages profiler might be able to as well?

Karl

Re: curved roof and cadimage roof builder

Rex Maximilian — Mon, 12 Nov 2007 11:13:33 GMT

Pandji wrote:
I've curved roof built by 'mesh to roof' . 'the mesh to roof' generate that roof become segmented. is it possible if i draw curved roof not in segmented (one part curved roof)?

then i'll using cadimage roof builder so my curved roof have looks like simple roof as image i attached.

thanks

Using the mesh to roof creates a LOT of roofs. Cadimage Accessories will place a unique object for EACH of them. I'm not sure that's what you want.