topic Re: CREATING SOFFITS in Modeling

CREATING SOFFITS

Anonymous — Thu, 25 May 2023 16:32:12 GMT

How do you create a soffit & fascia WITHOUT GETTING DOUBLE LINES WERE THEY MEET. We have been using walls for the fascia and slabs for the soffit but they don't join like walls so we are getting additinal lines in eithe ???????????

Re: CREATING SOFFITS

Anonymous — Wed, 13 Jun 2007 17:47:30 GMT

Create a Complex Profile of the soffit & fascia together. That way you can stretch the soffit to the desired width, We do that works great.

Re: CREATING SOFFITS

Anonymous — Wed, 13 Jun 2007 18:16:42 GMT

WE ARE CURRENLY USING ACAD 9 ???????? NO COMPLEX PROFILE TOOL

Re: CREATING SOFFITS

rjwilden — Wed, 13 Jun 2007 18:16:44 GMT

Tell me how do you get horizontal soffit to clean up with a soffit at a gable end. I tried this for a bit but gave ,as it looked terrible at the corners, and went back to the buggy Cadimage roof tool.

Richard.

Re: CREATING SOFFITS

Steve Jepson — Wed, 13 Jun 2007 19:14:38 GMT

rjwilden wrote:
Tell me how do you get horizontal soffit to clean up with a soffit at a gable end. I tried this for a bit but gave ,as it looked terrible at the corners, and went back to the buggy Cadimage roof tool.

Richard.

can you post a picture?

Try using SEO ?

Re: CREATING SOFFITS

Anonymous — Wed, 13 Jun 2007 19:19:12 GMT

THANKS FOR THE TIP I SOLVE MY PROBLEM BY USING A ROOF INSTAEDY OF A SLAB THEN I USED THE TRIM TO ROOF COMMAND TO INTERSECT FACIA OF AND THE SOFFIT.