https://community.graphisoft.com/t5/Modeling/Zone-stamp-identifier/m-p/83279#M43349 Haven't tried it but I'm thinking it won't be easy (if possible). Say you have a circular room. Is the length of the room the largest dimension or the average? After thinking about this problem a while back I realized that the simplest way is to just create a separate block which would have this information. That way I can specify graphically where I want the dimensions to be limited to. I use it for preliminary design and then change it out for CDs.<BR /> <BR /> And then again, if it really IS possible to have this in a zone tag, I'd like to know also. Fri, 13 May 2005 03:07:45 GMT Anonymous 2005-05-13T03:07:45Z https://community.graphisoft.com/t5/Modeling/Zone-stamp-identifier/m-p/83278#M43348 <DIV class="actalk-migrated-content"><T>Is there any way to put a length and width onto a zone identifier tag? (Am using Zone Identifier 2). I would love to have it show up on the drawing. Along with the area and perimeter.<BR /> <BR /> I am not a very good GDL user, so instructions would be very helpful.</T></DIV> Thu, 12 May 2005 16:06:41 GMT https://community.graphisoft.com/t5/Modeling/Zone-stamp-identifier/m-p/83278#M43348 Tom Krowka 2005-05-12T16:06:41Z https://community.graphisoft.com/t5/Modeling/Zone-stamp-identifier/m-p/83279#M43349 Haven't tried it but I'm thinking it won't be easy (if possible). Say you have a circular room. Is the length of the room the largest dimension or the average? After thinking about this problem a while back I realized that the simplest way is to just create a separate block which would have this information. That way I can specify graphically where I want the dimensions to be limited to. I use it for preliminary design and then change it out for CDs.<BR /> <BR /> And then again, if it really IS possible to have this in a zone tag, I'd like to know also. Fri, 13 May 2005 03:07:45 GMT https://community.graphisoft.com/t5/Modeling/Zone-stamp-identifier/m-p/83279#M43349 Anonymous 2005-05-13T03:07:45Z