topic Re: Trimmed door openings? in Modeling

Trimmed door openings?

lagodue — Thu, 25 May 2023 16:20:40 GMT

Is there any way to create an empty opening (no door) that has the same trim (casing) as a door?

Re: Trimmed door openings?

__archiben — Wed, 18 May 2005 03:07:59 GMT

lagodue wrote:
Is there any way to create an empty opening (no door) that has the same trim (casing) as a door?

yes - use a simple door - either D1 wood or metal - and turn the leaf off in the settings, make the frame non-existent, etc . . . and then turn on trims.

HTH
~/archiben

Re: Trimmed door openings?

lagodue — Wed, 18 May 2005 14:37:18 GMT

OK
tried this, but no joy. i set panel thickness to zero (there is no on/off button for the door panel) and door still appears as a single line plane. any additional input would help.
Thx

Re: Trimmed door openings?

lagodue — Wed, 18 May 2005 14:45:23 GMT

disregard previous message - solution is to select "empty" for panel type.

Re: Trimmed door openings?

__archiben — Thu, 19 May 2005 00:25:54 GMT

lagodue wrote:
disregard previous message - solution is to select "empty" for panel type.

that's what i meant by turning the leaf 'off' in the settings

cheers
~/archiben