https://community.graphisoft.com/t5/Modeling/Complex-profile-edge-problems/m-p/86792#M45338 yeah - me too. i've only just started using complex profiles (i still dislike their concept). i just figured it was a limitation. and since it's only happened to me with a 12mm panel joint i didn't really care too much.<BR /> <BR /> and yes - the complex profile window shows it as a curved fill edge . . .<BR /> <BR /> ~/archiben Tue, 06 Feb 2007 21:40:25 GMT __archiben 2007-02-06T21:40:25Z https://community.graphisoft.com/t5/Modeling/Complex-profile-edge-problems/m-p/86791#M45337 <DIV class="actalk-migrated-content"><T>I cannot figure out what is going on with this profile. I have built others and have not had the problem when my curves change into straight lines. Maybe somebody has a idea about what happened. In the complex profile tool everything looks fine but when I apply it to a wall and then do a section the curves change into a few lines.</T></DIV><BR /><IMG src="http://community.graphisoft.com/t5/image/serverpage/image-id/75178i34976704A78EA670/image-size/large?v=v2&amp;px=999" border="0" alt="counter top edge.jpg" title="counter top edge.jpg" /> Tue, 06 Feb 2007 18:41:22 GMT https://community.graphisoft.com/t5/Modeling/Complex-profile-edge-problems/m-p/86791#M45337 toofuerte 2007-02-06T18:41:22Z https://community.graphisoft.com/t5/Modeling/Complex-profile-edge-problems/m-p/86792#M45338 yeah - me too. i've only just started using complex profiles (i still dislike their concept). i just figured it was a limitation. and since it's only happened to me with a 12mm panel joint i didn't really care too much.<BR /> <BR /> and yes - the complex profile window shows it as a curved fill edge . . .<BR /> <BR /> ~/archiben Tue, 06 Feb 2007 21:40:25 GMT https://community.graphisoft.com/t5/Modeling/Complex-profile-edge-problems/m-p/86792#M45338 __archiben 2007-02-06T21:40:25Z