topic EDIT ZONE SHAPES in Modeling

EDIT ZONE SHAPES

Tom Krowka — Tue, 20 Jun 2006 01:14:35 GMT

Any way to edit zone shapes in V10? I have zone that were V9 zones in the migrated v10 .pln. When I select the zone and get the pet palette, no choice to add nodes or offset edges as previously was able to do in V9.

It is set to the polygon method. All I can do is drag, multiply, etc. About half the typical palette.

Re: EDIT ZONE SHAPES

Djordje — Tue, 20 Jun 2006 03:38:38 GMT

Tom wrote:
Any way to edit zone shapes in V10? I have zone that were V9 zones in the migrated v10 .pln. When I select the zone and get the pet palette, no choice to add nodes or offset edges as previously was able to do in V9.

It is set to the polygon method. All I can do is drag, multiply, etc. About half the typical palette.

Is your zone fill visible? If it is, you should be able to edit it like any polygon - by clicking on the nodes and edges, not the stamp.

Re: EDIT ZONE SHAPES

Tom Krowka — Tue, 20 Jun 2006 12:54:29 GMT

Actually, I knew that. thanks for the reminder.