topic Re: Joint lines not showing in plotmaker in Modeling

Joint Lines/Reveals

Anonymous — Wed, 07 Dec 2005 21:56:10 GMT

I constructed a truss using linework and subtracted it from the exterior wall of my building to create joint lines. The joints show up in AC, but not plotmaker. Has anyone ran into this problem?

Re: Joint lines not showing in plotmaker

James Murray — Thu, 08 Dec 2005 15:58:55 GMT

Sounds like pen settings. Make sure the pen of the subtraction isn't white in PM. It can't be layers, assuming the wall itself is visible.

Re: Joint lines not showing in plotmaker

Anonymous — Thu, 08 Dec 2005 23:38:27 GMT

It is not a pen issue, I tried that. It is wierd that it they show up in AC, but not in PM. The reveals even generate a shadow in AC and not in PM. They also show up in section when they are being cut through, but still not in elevation.

Re: Joint Lines/Reveals

Djordje — Fri, 09 Dec 2005 16:15:06 GMT

Kevin wrote:
I constructed a truss using linework and subtracted it from the exterior wall of my building to create joint lines. The joints show up in AC, but not plotmaker. Has anyone ran into this problem?

Any chance on getting a screen shot?

Are the layers in the placed view OK?

Re: Joint Lines/Reveals

Djordje — Fri, 09 Dec 2005 16:20:48 GMT

Kevin,

Please do not duplicate the topics. If you asked the question once, don't ask it again. Creates confusion.