https://community.graphisoft.com/t5/Modeling/3D-Section/m-p/113566#M59954 <DIV class="actalk-migrated-content"><T>This is probably a dead silly question, but i'm having trouble with the 3d sections in Archicad 10. When i use the marquee tool &amp; press F5, it will only bring up the 3d section for that particular floor. I need complete 3d sections of the building. Are there any settings i need to change to achieve this?<BR /> <BR /> Also, when i save 2d drawings to jpg or pdf, and use them in photoshop, the quality of the line is very bad. What is the best way to to go about moving a drawing to photoshop to create a photo montage?<BR /> <BR /> I had a look through loads of pages of the forum but couldn't find it. I would be very grateful for any help you could give me on this matter as i would need to do both these things asap for my uni hand in! Left to the last minute, ooops!</T></DIV> Mon, 14 Jan 2008 15:31:55 GMT Anonymous 2008-01-14T15:31:55Z https://community.graphisoft.com/t5/Modeling/3D-Section/m-p/113566#M59954 <DIV class="actalk-migrated-content"><T>This is probably a dead silly question, but i'm having trouble with the 3d sections in Archicad 10. When i use the marquee tool &amp; press F5, it will only bring up the 3d section for that particular floor. I need complete 3d sections of the building. Are there any settings i need to change to achieve this?<BR /> <BR /> Also, when i save 2d drawings to jpg or pdf, and use them in photoshop, the quality of the line is very bad. What is the best way to to go about moving a drawing to photoshop to create a photo montage?<BR /> <BR /> I had a look through loads of pages of the forum but couldn't find it. I would be very grateful for any help you could give me on this matter as i would need to do both these things asap for my uni hand in! Left to the last minute, ooops!</T></DIV> Mon, 14 Jan 2008 15:31:55 GMT https://community.graphisoft.com/t5/Modeling/3D-Section/m-p/113566#M59954 Anonymous 2008-01-14T15:31:55Z https://community.graphisoft.com/t5/Modeling/3D-Section/m-p/113567#M59955 When drawing the Marquee make sure that is it set to the Thick Marquee not the thin one. This will allow you to do the whole building. <BR /> <BR /> When exporting 2D plans try printing it to a PDF then opening in photoshop. Mon, 14 Jan 2008 15:40:00 GMT https://community.graphisoft.com/t5/Modeling/3D-Section/m-p/113567#M59955 Anonymous 2008-01-14T15:40:00Z