https://community.graphisoft.com/t5/Modeling/Missing-3d-Models/m-p/119300#M63142 do you using 2 archicad application at the same time? i tried this method before, but the update of the module was not very good, some modification can show.<BR /> <BR /> then I open only one AC at the same time, after editing the module, save and close, and open the project again. and work fine<BR /> <BR /> or may be<BR /> <BR /> you hid some layers in your original file. Tue, 18 Nov 2008 03:33:34 GMT Anonymous 2008-11-18T03:33:34Z https://community.graphisoft.com/t5/Modeling/Missing-3d-Models/m-p/119299#M63141 <DIV class="actalk-migrated-content"><T>Hellloooo Everybody.<BR /> I have a 3d model hotlinked into my .pln file.<BR /> It comes up just fine in the 3d window in the original file, but not in the hotlinked one. <BR /> I drew some slabs in the hotlinked file, nothing came up then too. Just a blank window with a black line in the center.<BR /> <BR /> Any Ideas?</T></DIV> Thu, 25 May 2023 16:30:41 GMT https://community.graphisoft.com/t5/Modeling/Missing-3d-Models/m-p/119299#M63141 Anonymous 2023-05-25T16:30:41Z https://community.graphisoft.com/t5/Modeling/Missing-3d-Models/m-p/119300#M63142 do you using 2 archicad application at the same time? i tried this method before, but the update of the module was not very good, some modification can show.<BR /> <BR /> then I open only one AC at the same time, after editing the module, save and close, and open the project again. and work fine<BR /> <BR /> or may be<BR /> <BR /> you hid some layers in your original file. Tue, 18 Nov 2008 03:33:34 GMT https://community.graphisoft.com/t5/Modeling/Missing-3d-Models/m-p/119300#M63142 Anonymous 2008-11-18T03:33:34Z