topic Re: ACAD 15 - Cut Fill on Plan - Origin in Modeling

ACAD 15 - Cut Fill on Plan - Origin

Anonymous — Sat, 03 Mar 2012 12:14:57 GMT

How does one cotrol the origin of the cut fill as displayed on Plan? I want to be able to show individual bricks on plan. See attached:
Any suggestions welcome.

Re: ACAD 15 - Cut Fill on Plan - Origin

Erika Epstein — Sat, 03 Mar 2012 18:25:01 GMT

Zak,

Your link isn't working. Alternatively you can add a screen shot as an attachment to your post, see the bottom of the page.

Re: ACAD 15 - Cut Fill on Plan - Origin

Karl Ottenstein — Sun, 04 Mar 2012 00:32:11 GMT

[Sorry Erika/Zak- that was my fault. Zak double-posted but did originally post the screenshot properly, and I deleted the duplicate... but that apparently deleted the shared screenshot.... Karl/Moderator-hat-on]

Re: ACAD 15 - Cut Fill on Plan - Origin

Anonymous — Sun, 04 Mar 2012 10:52:08 GMT

Thanks... fixed it. Any genius answer yet?

Re: ACAD 15 - Cut Fill on Plan - Origin

Anonymous — Thu, 24 May 2012 08:12:09 GMT

Hi... As I'm not a master in archicad ... I'm not sure its the best way or not ! but you can make a detail or worksheet of your section which you draw and then select the cut fill , change the " construction method " in Fill selection Setting From " Relative to the project Origin " to " relative to the fill origin " then change the Origin Of your fill brick.

hamedkassaei