topic Re: Wall sheeting not showing roller door in Modeling

Wall sheeting not showing roller door

Anonymous — Tue, 23 May 2023 14:42:35 GMT

Hi,

I have a concrete dado with wall sheeting above. The wall sheeting is created with object cladding. The roller door works with the concrete but its not showing in the sheeting. How do I link the two together? How to get a hole in the object?

Cheers.

Re: Wall sheeting not showing roller door

Gerald Hoffman — Sun, 17 Jul 2011 18:58:10 GMT

I think we need a little more information. Is the cladding you mention CadImage's Cladding tool? If you could post an image of the plan view of what your wall condition looks like it would help.

Cheers,

Re: Wall sheeting not showing roller door

Barry Kelly — Mon, 18 Jul 2011 02:25:36 GMT

I'd be guessing you have created this "concrete dado with sheeting above" wall out of two separate walls.
The roller door belongs to the concrete dado wall and therefore will not cut the sheeting wall.
You will need to add a separate empty opening to the sheeting wall.
But note there will be no automatic relationship between the roller door and this separate opening - their sizes and positions need to be adjusted individually.

Otherwise create a complex profile wall from the two separate walls.
Then it will behave as a single wall and the openings will work as you expect them to.

Barry.

Re: Wall sheeting not showing roller door

Anonymous — Mon, 18 Jul 2011 02:36:45 GMT

Hi,
I have attached an image, hopefully that explains it better.
No, I dont have Cadimage, but I'll have to look into it.

Cheers. [/img]

Re: Wall sheeting not showing roller door

Anonymous — Mon, 18 Jul 2011 03:21:49 GMT

kcdraftingdesign wrote:
Hi,
I have attached an image, hopefully that explains it better.
No, I dont have Cadimage, but I'll have to look into it.

Cheers. [/img]

Try attaching image again. Either use the "Choose File" button below where you type your message and browse to your image, or use a hyperlink to an image located elsewhere on the www.