https://community.graphisoft.com/t5/Modeling/Trimming-walls-to-curved-stairs/m-p/16331#M7748 <DIV class="actalk-migrated-content"><R>Is there a simple way to trim walls to curved stairs? With stairs with straight angles, I've always used a roof as a trimming tool. I need to fill in the space between the bottom of the stair and the floor.<BR /> ________<BR /> <A href="http://wwweed.com/" target="_blank">Weed</A></R></DIV> Tue, 23 May 2023 13:40:49 GMT Anonymous 2023-05-23T13:40:49Z https://community.graphisoft.com/t5/Modeling/Trimming-walls-to-curved-stairs/m-p/16331#M7748 <DIV class="actalk-migrated-content"><R>Is there a simple way to trim walls to curved stairs? With stairs with straight angles, I've always used a roof as a trimming tool. I need to fill in the space between the bottom of the stair and the floor.<BR /> ________<BR /> <A href="http://wwweed.com/" target="_blank">Weed</A></R></DIV> Tue, 23 May 2023 13:40:49 GMT https://community.graphisoft.com/t5/Modeling/Trimming-walls-to-curved-stairs/m-p/16331#M7748 Anonymous 2023-05-23T13:40:49Z https://community.graphisoft.com/t5/Modeling/Trimming-walls-to-curved-stairs/m-p/16332#M7749 <BLOCKQUOTE>dukaos wrote:<BR />Is there a simple way to trim walls to curved stairs? With stairs with straight angles, I've always used a roof as a trimming tool. I need to fill in the space between the bottom of the stair and the floor.</BLOCKQUOTE> Solid Element Op - Subtract with Upwards Extrusion: stair operator, wall operand. Some GDL parts have problems being part of SEOps, but I just tested with an 8' radius spiral stair with a round wall below and it trimmed just fine.<BR /> <BR /> HTH,<BR /> Karl Mon, 13 Sep 2004 22:05:12 GMT https://community.graphisoft.com/t5/Modeling/Trimming-walls-to-curved-stairs/m-p/16332#M7749 Karl Ottenstein 2004-09-13T22:05:12Z