topic Re: curve wall in Modeling

curve wall

Anonymous — Wed, 24 May 2023 18:00:02 GMT

HI ALL
1- I try to made that curved wall ( in up )
I try with profile A I nave the the wall but I cant open windows or door in it
I try again with normal wall and use SEO with profile wall B I have the wall but I cant see correctly it in plans
2- any way to draw profile up the curve with archicad tools .

thank you

Re: curve wall

Dwight — Sat, 29 May 2010 20:01:35 GMT

Make a plain wall instead.

Use the Solid Element Operation tool to trim away the excess.

The operator will be your arched roof elements.

This wall will support conventional openings.

Re: curve wall

Erika Epstein — Sat, 29 May 2010 22:24:23 GMT

The Curtain Wall can trim a regular wall by connecting it.

Select wall & Curtain Wall
Design>Modify Curtain wall>Connect Wall

see note on attached screen shot. As in other areas of archicad when a curve turns back on itself what you are trimming with it may have to be split into two, or else break the curtain wall into appropriate sections.

Re: curve wall

Anonymous — Sat, 29 May 2010 23:46:32 GMT

thank you I know about connect wall but never done but spilt is good idea I try it to right part and left part and cut the wall but the middle part make some problem I will try again . thank you
for curved roof not allow me to do that because some part of this cw come under another part but I will try to split this roof to 2 roofs thank you all
but
2- any way to draw profile up the curve with archicad tools .