https://community.graphisoft.com/t5/Modeling/door-cavity-closure-not-working/m-p/156436#M84302 <DIV class="actalk-migrated-content"><T>i want to use a 50mm cavity closure (pre-fabricated) on a composite wall I have which is as follows:<BR /> <BR /> - outer skin 15mm wide<BR /> - core skin 100mm wide<BR /> - inner skin 15mm wide<BR /> <BR /> It might sound a bit strange but its a timber stud partition, and I want it to illustrate so that there is a timber stud each side of the door frame.<BR /> <BR /> The closures work fine on my other brick/block walls (with 100mm outer skins) but on this one because the outer skins are only 15mm, the closure will not show up?</T></DIV> Wed, 24 May 2023 11:06:28 GMT Anonymous 2023-05-24T11:06:28Z https://community.graphisoft.com/t5/Modeling/door-cavity-closure-not-working/m-p/156436#M84302 <DIV class="actalk-migrated-content"><T>i want to use a 50mm cavity closure (pre-fabricated) on a composite wall I have which is as follows:<BR /> <BR /> - outer skin 15mm wide<BR /> - core skin 100mm wide<BR /> - inner skin 15mm wide<BR /> <BR /> It might sound a bit strange but its a timber stud partition, and I want it to illustrate so that there is a timber stud each side of the door frame.<BR /> <BR /> The closures work fine on my other brick/block walls (with 100mm outer skins) but on this one because the outer skins are only 15mm, the closure will not show up?</T></DIV> Wed, 24 May 2023 11:06:28 GMT https://community.graphisoft.com/t5/Modeling/door-cavity-closure-not-working/m-p/156436#M84302 Anonymous 2023-05-24T11:06:28Z