topic COMPOSITE INTERSECTION PRIORITIES in Modeling

COMPOSITE INTERSECTION PRIORITIES

davor_r — Wed, 24 May 2023 07:01:20 GMT

Can anybody give me advice how to set up priorities for concrete and mortar in examples i captured.

In "capture" I set concrete to 900 priority, and mortar is lower. I don't like this solution because mortar doesn't fit all around wall structures. Concrete is over mortar at some edges.

In "capture2" I set concrete to 900 priority, and mortar is higher. In this case mortar cuts concrete and thats not good to.

Is there any rule how to set up material priorities?

Thanks

Re: COMPOSITE INTERSECTION PRIORITIES

davor_r — Thu, 17 Apr 2014 09:16:53 GMT

attachments

Re: COMPOSITE INTERSECTION PRIORITIES

davor_r — Thu, 17 Apr 2014 09:17:25 GMT

atachment

Re: COMPOSITE INTERSECTION PRIORITIES

Eduardo Rolon — Thu, 17 Apr 2014 13:06:05 GMT

After a quick try way I have gotten that condition clean is to use the wall end tool, the step as are:

1. Extend the wall that need the paster
2. Apply the Wall End
3. Move the wall and snap to the inside of the plaster on the other wall.

Re: COMPOSITE INTERSECTION PRIORITIES

Eduardo Rolon — Thu, 17 Apr 2014 13:06:31 GMT

Step 2

Re: COMPOSITE INTERSECTION PRIORITIES

Eduardo Rolon — Thu, 17 Apr 2014 13:07:19 GMT

The somewhat ugly result.

Re: COMPOSITE INTERSECTION PRIORITIES

Eduardo Rolon — Thu, 17 Apr 2014 13:11:00 GMT

What did you use on this case for the return?