topic Re: CURVED SECTIONS in Modeling

CURVED SECTIONS

Anonymous — Tue, 15 Dec 2009 18:18:51 GMT

Maybe this is dump question but is it possible to make curved section in archicad 12

Re: CURVED SECTIONS

Anonymous — Tue, 15 Dec 2009 18:33:58 GMT

I'm afraid not. Curved sections are not even available in AC13. You could try creating several short individual sections and join them back together on a layout. It's not really curved, but it's the best we can do.

Re: CURVED SECTIONS

Gerald Hoffman — Tue, 15 Dec 2009 21:23:53 GMT

You can make a curved 3D section view but I think you are looking for a 2D section cut.

Re: CURVED SECTIONS

Eduardo Rolon — Tue, 15 Dec 2009 21:39:24 GMT

If you can see it in the 3D window you can save it as a 3D Document. The only thing to configure is the 3D View Settings to see the model in elevation.

Re: CURVED SECTIONS

Anonymous — Wed, 16 Dec 2009 03:19:08 GMT

How did you to the 3d curved section?

Re: CURVED SECTIONS

Anonymous — Wed, 16 Dec 2009 07:01:51 GMT

I knew for this 3d curved secion, but I was looking for 2d section plan... Never mind, I'll try with several shorter sections and with matching them. Anyway thanks for helping...

Re: CURVED SECTIONS

Dwight — Wed, 16 Dec 2009 07:06:07 GMT

Profoxcg wrote:
How did you to the 3d curved section?

A circular marquee is made by magic wanding a circle.

Re: CURVED SECTIONS

Anonymous — Wed, 16 Dec 2009 07:08:01 GMT

😉 sounds good thanks

Re: CURVED SECTIONS

Dwight — Wed, 16 Dec 2009 07:09:59 GMT

In fact, even a magic wanded marquee will follow even a negative/void edge in Archicad 13, where some prior editions did a shortcut.