https://community.graphisoft.com/t5/Modeling/windows-and-doors-project-past-composite-wall-structure/m-p/159248#M85974 <DIV class="actalk-migrated-content"><T>Whoever can help me out with this difficulty, i would greatly appreciate it! I made a custom wall and all the windows and door project well past the wall itself.... is there a way to solve this problem?</T></DIV> Wed, 24 May 2023 10:56:08 GMT Anonymous 2023-05-24T10:56:08Z https://community.graphisoft.com/t5/Modeling/windows-and-doors-project-past-composite-wall-structure/m-p/159248#M85974 <DIV class="actalk-migrated-content"><T>Whoever can help me out with this difficulty, i would greatly appreciate it! I made a custom wall and all the windows and door project well past the wall itself.... is there a way to solve this problem?</T></DIV> Wed, 24 May 2023 10:56:08 GMT https://community.graphisoft.com/t5/Modeling/windows-and-doors-project-past-composite-wall-structure/m-p/159248#M85974 Anonymous 2023-05-24T10:56:08Z https://community.graphisoft.com/t5/Modeling/windows-and-doors-project-past-composite-wall-structure/m-p/159249#M85975 Have you checked your opening reference lines in the Complex Profile settings dialog? These are the red lines shown in the attached image. In this case I have a partition with wood trim added the profile. The opening reference lines had to be moved back to the gypsum board edges to have my openings in the correct place. Thu, 14 Jun 2012 14:30:34 GMT https://community.graphisoft.com/t5/Modeling/windows-and-doors-project-past-composite-wall-structure/m-p/159249#M85975 Jere 2012-06-14T14:30:34Z