https://community.graphisoft.com/t5/Modeling/Folded-Section/m-p/170694#M92502 <BLOCKQUOTE>Is it possible to create a folded section, where the section line bends on an angle?</BLOCKQUOTE> No. But it's easy to create views from two sections, and join the views on a layout. Tue, 10 Feb 2009 21:48:08 GMT Thomas Holm 2009-02-10T21:48:08Z https://community.graphisoft.com/t5/Modeling/Folded-Section/m-p/170693#M92501 <DIV class="actalk-migrated-content"><T>Is it possible to create a folded section, where the section line bends on an angle? I am trying to cut a section thru 2 fireplaces that are back-to-back but at angles to each other. For ease of graphics I'd like to cut at 90 degrees to each firebox.<BR /> <BR /> Any suggestions would be helpful.</T></DIV> Tue, 10 Feb 2009 21:27:09 GMT https://community.graphisoft.com/t5/Modeling/Folded-Section/m-p/170693#M92501 Anonymous 2009-02-10T21:27:09Z https://community.graphisoft.com/t5/Modeling/Folded-Section/m-p/170694#M92502 <BLOCKQUOTE>Is it possible to create a folded section, where the section line bends on an angle?</BLOCKQUOTE> No. But it's easy to create views from two sections, and join the views on a layout. Tue, 10 Feb 2009 21:48:08 GMT https://community.graphisoft.com/t5/Modeling/Folded-Section/m-p/170694#M92502 Thomas Holm 2009-02-10T21:48:08Z https://community.graphisoft.com/t5/Modeling/Folded-Section/m-p/170695#M92503 A single section can't have angled direction. With a concave angle you can have distant elements that became near each other. With a convex angle some portion of the drawing would be overlapping, or even duplicate.<BR /> <BR /> Anyway, the solution can be to create 2 sections and join them on a single Layout.<BR /> You can also try with the Interior Elevation Tool Tue, 10 Feb 2009 21:48:52 GMT https://community.graphisoft.com/t5/Modeling/Folded-Section/m-p/170695#M92503 rocorona 2009-02-10T21:48:52Z