topic Re: Section doesn't show skin separator lines in Modeling

Section doesn't show skin separator lines

Anonymous — Thu, 20 Aug 2009 21:29:28 GMT

I can't get the skin separator lines to display in my sections. What am I doing wrong?

The attached image explains it best, I think.

Re: Section doesn't show skin separator lines

Erika Epstein — Fri, 21 Aug 2009 00:33:33 GMT

In general, Check over-ride fills and then you will have this option available.

I am not sure which wall you are unhappy with.

Re: Section doesn't show skin separator lines

Anonymous — Fri, 21 Aug 2009 00:59:11 GMT

None of the separator lines are showing, so it's all of them that I'm unhappy with. I've tried every variation on Model View Options with no luck.

Re: Section doesn't show skin separator lines

Rod Jurich — Fri, 21 Aug 2009 01:25:12 GMT

LINZ wrote:
/.. What am I doing wrong? /......

Lindsay, you need to have a different name for the finish skin to show the separator line.
If the finish skin is to be the same fill as the core you will need to have a
different named fill, core fill 1, core fill 2.

Re: Section doesn't show skin separator lines

Anonymous — Fri, 21 Aug 2009 03:20:28 GMT

Thank you very much! I didn't know that was the case...