https://community.graphisoft.com/t5/Modeling/Stairmaster/m-p/176887#M95922 <DIV class="actalk-migrated-content"><T>I am having trouble with stairs. I get most of the procedure, but there are spots I don't get; <BR /> 1.) On a set of stairs that are already drawn, how can I raise or drop them a story and have the visible area show as visible on the appropriate story? I drop the stair set in section rather than figuring out all of the parameters again. <BR /> 2.) How do I select which part of the stair set is top or bottom and have it show accordingly? I get in the section view, find out they are backward, go to a plan view and rotate the stair set and check it again in section. In Revit you can push a button and reverse the direction of the stair set. How do you do it here? <BR /> Thanks! <BR /> Rogerjavascript:emoticon(':roll:')</T></DIV> Thu, 25 May 2023 14:56:50 GMT Anonymous 2023-05-25T14:56:50Z https://community.graphisoft.com/t5/Modeling/Stairmaster/m-p/176887#M95922 <DIV class="actalk-migrated-content"><T>I am having trouble with stairs. I get most of the procedure, but there are spots I don't get; <BR /> 1.) On a set of stairs that are already drawn, how can I raise or drop them a story and have the visible area show as visible on the appropriate story? I drop the stair set in section rather than figuring out all of the parameters again. <BR /> 2.) How do I select which part of the stair set is top or bottom and have it show accordingly? I get in the section view, find out they are backward, go to a plan view and rotate the stair set and check it again in section. In Revit you can push a button and reverse the direction of the stair set. How do you do it here? <BR /> Thanks! <BR /> Rogerjavascript:emoticon(':roll:')</T></DIV> Thu, 25 May 2023 14:56:50 GMT https://community.graphisoft.com/t5/Modeling/Stairmaster/m-p/176887#M95922 Anonymous 2023-05-25T14:56:50Z https://community.graphisoft.com/t5/Modeling/Stairmaster/m-p/176888#M95923 1.) Try Cut and Paste. Then adjust the 2D representation (select the appropriate type in the settings box.<BR /> <BR /> 2. Try the Mirror command. Wed, 01 Oct 2008 09:18:39 GMT https://community.graphisoft.com/t5/Modeling/Stairmaster/m-p/176888#M95923 Thomas Holm 2008-10-01T09:18:39Z