topic Door shown at 45 degree angle in Documentation

Door shown at 45 degree angle

dhnguyen — Thu, 06 Feb 2025 11:40:25 GMT

Where do I go to change the setting of the door so that it shows the door swing at 45degree angle instead of 90 in plan view? I have been looking in "Door Selection Settings", but can't find it.

Thanks.

Re: Door shown at 45 degree angle

vistasp — Wed, 15 May 2019 14:17:47 GMT

Apart from changing it graphically (using a hotspot) for a single door, you can change it in the parameters as well. If you're using doors from some other library, this might not be the case.

Re: Door shown at 45 degree angle

dhnguyen — Wed, 15 May 2019 15:19:05 GMT

Thanks for the screen shot, that helps a lot. So I went into "Opening" tab under "Custom Settings", and changed the "Opening Angle to 45 degree and it works, thanks!

Re: Door shown at 45 degree angle

vistasp — Wed, 15 May 2019 16:49:01 GMT

Glad it helped. So this was a non-GS library part?

Re: Door shown at 45 degree angle

dhnguyen — Wed, 15 May 2019 17:07:00 GMT

It's one of the doors from the standard library. Here's where I found it based on your screen shot. - see attached.

Re: Door shown at 45 degree angle

vistasp — Thu, 16 May 2019 05:47:48 GMT

You seem to be using multiple older (and very old) libraries at the same time... Any particular reason?

Re: Door shown at 45 degree angle

Erwin Edel — Thu, 16 May 2019 06:38:25 GMT

The load times for all those libraries and loading errors must be horrible