topic Re: Viewport Double Update in Documentation

Viewport Double Update

toman311 — Thu, 18 May 2023 15:23:19 GMT

I don't know why ArchiCAD is doing this, but every time I open up a sheet the viewports go through the update process twice. It really takes up a lot of time too on some sheets.

Does anybody know why this is and how I can stop it?

Re: Viewport Double Update

Lingwisyer — Wed, 05 Jun 2019 01:18:30 GMT

I set most of my views to manual update. Means that you need to check every view prior to publishing, but it also means that each time you make a small change, you do not get every view updating even if the change is not actually visible.

Ling.

Re: Viewport Double Update

toman311 — Wed, 05 Jun 2019 21:52:01 GMT

Thanks for the reply.

I think I might miss something and create a mistake if I did that. I'd rather wait then make a mistake.

Thanks for the tip, but I don't think that would work for me.

Re: Viewport Double Update

Lingwisyer — Thu, 06 Jun 2019 01:28:25 GMT

toman311 wrote:
I think I might miss something and create a mistake if I did that. I'd rather wait then make a mistake.

Before publishing, you can always go to the drawing manager and update all of the internal drawings. You should not miss updating any this way.

Ling.

Re: Viewport Double Update

ahmad525 — Tue, 28 Mar 2023 05:20:41 GMT

hey

was this issue fixed at all or have you found any solution ?

im having the same issue with AC25.

its annoying and makes everything slow and sometime it takes up to 1-2 minutes till you be able to do any changes or view.