https://community.graphisoft.com/t5/Documentation/Zone-Stamp-always-centered-on-zone/m-p/243043#M37095 I'm not aware of an auto setting, but it will place the stamp where you confirm (hammer) the room. Typically, I pick the center of the geometry or, if equipment, casework, and/or furniture is visible, in a clear area of the floor.<BR /> <BR /> If I have a line of spaces and want the stamps to line up, I will either set a guideline before or after the first placed stamp, or I will drag copies and then go back and edit the zone id.<BR /> <BR /> Hope this helps. Sun, 10 May 2020 06:37:56 GMT Marc H 2020-05-10T06:37:56Z https://community.graphisoft.com/t5/Documentation/Zone-Stamp-always-centered-on-zone/m-p/243042#M37094 <DIV class="actalk-migrated-content"><T>Is it possible to have a zone stamp always centered vertically and horizontally inside the zone?<BR /> <BR /> This is possible with the "Area Text" in Fill...and its such a nice feature when doing quick zone sketches.<BR /> <BR /> Kind Regards</T></DIV> Fri, 19 May 2023 13:46:09 GMT https://community.graphisoft.com/t5/Documentation/Zone-Stamp-always-centered-on-zone/m-p/243042#M37094 joimagg 2023-05-19T13:46:09Z https://community.graphisoft.com/t5/Documentation/Zone-Stamp-always-centered-on-zone/m-p/243043#M37095 I'm not aware of an auto setting, but it will place the stamp where you confirm (hammer) the room. Typically, I pick the center of the geometry or, if equipment, casework, and/or furniture is visible, in a clear area of the floor.<BR /> <BR /> If I have a line of spaces and want the stamps to line up, I will either set a guideline before or after the first placed stamp, or I will drag copies and then go back and edit the zone id.<BR /> <BR /> Hope this helps. Sun, 10 May 2020 06:37:56 GMT https://community.graphisoft.com/t5/Documentation/Zone-Stamp-always-centered-on-zone/m-p/243043#M37095 Marc H 2020-05-10T06:37:56Z