https://community.graphisoft.com/t5/Documentation/Profile-Beam-Top-and-Bottom-Elevation/m-p/307128#M47827 <P>I just checked, but you can do this with a text label using autotext. You should be able to list both top and bottom elevation to project zero or reference levels etc</P><P>&nbsp;</P><P>To be sure: you have the 'nominal width/height' sorted out in the complex profile?</P> Thu, 23 Sep 2021 11:14:02 GMT Erwin Edel 2021-09-23T11:14:02Z https://community.graphisoft.com/t5/Documentation/Profile-Beam-Top-and-Bottom-Elevation/m-p/306537#M47826 <P>Is there a way to get a readout of the bottom and top elevation of a selected profile beam? &nbsp;All I can find is the center, which requires math to find the bottom or the top.</P> Sat, 18 Sep 2021 20:09:58 GMT https://community.graphisoft.com/t5/Documentation/Profile-Beam-Top-and-Bottom-Elevation/m-p/306537#M47826 R Muller 2021-09-18T20:09:58Z https://community.graphisoft.com/t5/Documentation/Profile-Beam-Top-and-Bottom-Elevation/m-p/307128#M47827 <P>I just checked, but you can do this with a text label using autotext. You should be able to list both top and bottom elevation to project zero or reference levels etc</P><P>&nbsp;</P><P>To be sure: you have the 'nominal width/height' sorted out in the complex profile?</P> Thu, 23 Sep 2021 11:14:02 GMT https://community.graphisoft.com/t5/Documentation/Profile-Beam-Top-and-Bottom-Elevation/m-p/307128#M47827 Erwin Edel 2021-09-23T11:14:02Z