topic Re: composite wall exterior intersections in Documentation

composite wall exterior intersections

oippam — Wed, 27 Apr 2022 13:26:25 GMT

Hi,

I am pretty new to Archicad and I am having an issue with exterior corners with composite materials. In the

attached image you can see the plywood peeking out at the corner. I tried looking through tutorials and this community page to figure it out. I am sure it is because I am not up to speed with correct terminology. How can I get the siding to wrap the corner. Normally it would not be an issue because most have corner boards, but this house's siding wraps the corner. Any help pointing to a tutorial would be greatly appreciated.

Thanks!

Matt

exterior corner - composite

Re: composite wall exterior intersections

Lee Hankins — Wed, 27 Apr 2022 13:27:57 GMT

It will likely be to do with building material priorities. The plywood will be higher than the siding causing it to pass through.

Re: composite wall exterior intersections

DGSketcher — Wed, 27 Apr 2022 13:41:34 GMT

@oippam See if this setting fixes it... You need to turn it on [Tick].

Re: composite wall exterior intersections

oippam — Wed, 27 Apr 2022 13:58:06 GMT

Thanks Lee!

I actually was playing around with that and it did not seem to work. I tried dropping the priority of all the plywood in the list to below the siding. What did work was applying the siding to the Fill Orientation.