topic Re: Returned wall end unwanted line between skins in Documentation

Returned wall end unwanted line between skins

Kinzy — Tue, 10 May 2022 07:34:55 GMT

As said in the title, while using the wall end tool, it creates an unwanted line between the outer skins where there should be none.

*Note: Line between identical fills is not the problem.

Re: Returned wall end unwanted line between skins

mija — Tue, 10 May 2022 08:05:54 GMT

If you turn off the line between identical fills does it go away?

Re: Returned wall end unwanted line between skins

Kinzy — Tue, 10 May 2022 13:51:35 GMT

It doesn't.

Re: Returned wall end unwanted line between skins

BrunoH — Wed, 11 May 2022 14:22:48 GMT

Hi,

The line appears because the material off the 2 faces aren't the same and or the 2 surfaces aren't the same. If it's possible for you to set the inside and the outside skins of the composite wall with the same material, then the line will be removed. Otherwise you can place a column with a complexe profile to replace the wall end.

Re: Returned wall end unwanted line between skins

ricorick — Mon, 16 May 2022 12:53:55 GMT

Thanks for helping with this question!