topic Re: Door transom height value in schedul in Documentation

Door transom height value in schedul

amitchristian — Thu, 28 Jul 2022 12:47:39 GMT

in door schedule, Door 25.gsm, which does not have option of transom by default, still shows transom height as 300.

Do we have any solution for this so that doors without transom do not show any value in schedule?

Re: Door transom height value in schedul

Laszlo Nagy — Fri, 29 Jul 2022 19:44:26 GMT

Unfortunately, this comes from the Library Part.

Every parameter that is defined in a Library Part was a default value. In the case of the "gs_transom_height" parameter, that default value seems to be 300 mm.

Even when the parameters is not used by the Library Part, the parameter value is still there and will be displayed in the schedule.

If the parameter is used, you set its value and that value (which may or may not be different from its default value) will be displayed in the schedule.

You should make a wish because Library Part parameters are not coded to respond correctly in such a use case.

Re: Door transom height value in schedul

amitchristian — Tue, 02 Aug 2022 10:47:47 GMT

Thank you so much for explaining the same.