topic Re: how to hide side lines from Slabs? (soffit situation) in Documentation

how to hide side lines from Slabs? (soffit situation)

cocoloco — Fri, 20 Dec 2024 13:22:50 GMT

Hello,

we are creating soffits in each and every room, we use slabs to do so. My hope is to show the soffits (logically) only inner lines , NOT side lines. (looks lame).

How do I HIDE the side lines of soffits so it looks clean? Otherwise, how else do you create soffits but show them on the floor plan/3d properly as well (without side lines?)

Thanks!

ON ATTACHED PHOTO, the red shows where the lines are not desirable, obviously, because that's not how soffits should look like in real or 3d or floor plan..

Operating system used: Mac Apple Silicon Sono,a 14.5

Re: how to hide side lines from Slabs? (soffit situation)

Eduardo Rolon — Sun, 23 Jun 2024 16:35:34 GMT

Assign an unique material for soffits
Go Into MVOs and create a New one for this plans
Select " Eliminate"

Re: how to hide side lines from Slabs? (soffit situation)

cocoloco — Sun, 23 Jun 2024 16:38:35 GMT

thank you, but will this show line to show the soffits edges, correct? I don't want to eliminate all the lines, only the sidelines.

Re: how to hide side lines from Slabs? (soffit situation)

Karl Ottenstein — Sun, 23 Jun 2024 17:21:20 GMT

Rather than 4 separate slabs, you can magic wand (or in the illustration, draw a rectangular slab snapping to opposite corners) a single slab to the interior wall edges... then pet-palette-subtract an offset slab the width of the soffit creating a hole... resulting in a single slab for all soffits.

If you want section cuts to look correct, you could do the soffits with a complex profiled beam. Lots of options, but I don't think you can get rid of the lines for two adjacent slabs in plan (hope I'm wrong).

Re: how to hide side lines from Slabs? (soffit situation)

cocoloco — Sun, 23 Jun 2024 18:28:08 GMT

That worked! Thank you!

Re: how to hide side lines from Slabs? (soffit situation)

Eduardo Rolon — Mon, 24 Jun 2024 12:37:24 GMT

Yes, it will remove the line for slabs that are touching and have the same surface material and cover fill.

Re: how to hide side lines from Slabs? (soffit situation)

Eduardo Rolon — Mon, 24 Jun 2024 12:39:26 GMT

Yes you can.

Since AC23:

https://help.graphisoft.com/AC/27/INT/index.htm?rhcsh=1&rhnewwnd=0&rhmapid=#t=_AC27_Help%2F140_UserInterfaceDialogBoxes%2F140_UserInterfaceDialogBoxes-39.htm&rhsearch=slab%20model%20view&rhhlterm=slab%20model%20view&rhsyns=%20