topic Re: 3D document cuts part of model in Documentation

3D document cuts part of model

Kaj_AL — Fri, 04 Oct 2024 21:12:06 GMT

Hi!

I have a recurring issue, which is obviously something I'm doing wrong but I can't for my life figure out what.

I have a 3D Document isometric view. When I updated the view from 3D it got cut on the right side of the image, and I can't figure out how to get it back.

My workflow (which I don't know if it is correct) is this:

1. Update a 3D axonometric view in the View Map.

2. Right click on my 3D Document in the Project Map and click "Redefine 3D Document based on Current 3D Window"

3. Update them in my layout.

No matter how much I zoom in and out I still get a cut in the model.

Thank you for your help!

Operating system used: Windows 11

Re: 3D document cuts part of model

Barry Kelly — Thu, 03 Oct 2024 02:43:06 GMT

Right click in the 3D Document and choose 'Open 3D Source'.

Is there a cut plane or marquee cutting the corner?

If so, turn it off and then right click in the 3D window and re-define your 3D Document.

Barry.

Re: 3D document cuts part of model

Kaj_AL — Wed, 09 Oct 2024 08:04:50 GMT

Thank you for you response!

In some way the issue was fixed without me knowing how it happened, and I can't replicate it again. They are not my best friends, the 3D documents.

/Kaj

Re: 3D document cuts part of model

Maaike — Fri, 06 Jun 2025 12:29:12 GMT

i've figured out how to solve it. I could not find the planes that where cutting my model. However, archicad was still cutting half of my model.
How to solve this: Right click on 3d view > filter and cut elements in 3d > Maruqee effect turn trim elements to marquee off > ok. To keep this setting in the model, redefine with current window settings, otherwise it will be gone after you change views! After this you can publish your 3d document with the whole model in it