Collaboration with other software
About model and data exchange with 3rd party solutions: Revit, Solibri, dRofus, Bluebeam, structural analysis solutions, and IFC, BCF and DXF/DWG-based exchange, etc.

How to show total wall area instead of individual wall

Anonymous
Not applicable
I am facing an issue with my paint schedule. Instead of showing the total wall area of a story, it's showing the individual wall area (See Fig-1). Which made my schedule too long. (See Fig-2)
I created this wall area using expression ( Net inside area + net outside area) (See Fig 3)

N.B- I have already merged Unifrom items. but the result is still the same.
1 REPLY 1
Barry Kelly
Moderator
You are scheduling the cost which I assume is a property calculated via an expression.
Because you have created it as a text property, the schedule will not sum them (can't sum text) and it assumes each wall is 'unique' due to this different value in each wall - therefore they will not merge as one item in the schedule.

I am not 100% sure, but if you change you property from a text value to a number, then it may ignore that they are different values and merge them all as one surface.

Also you may need to use a surface schedule rather than an element schedule.


Barry.
One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11