Collaboration with other software
About model and data exchange with 3rd party solutions: Revit, Solibri, dRofus, Bluebeam, structural analysis solutions, and IFC, BCF and DXF/DWG-based exchange, etc.

partial structure, dimensions and exporting to dwg

Anonymous
Not applicable
using partial structure and have separate set of dimensions on "entire model" and "without finishes" when translated to a dwg both sets of dimensions show up making a bit of a mess. Can't locate a setting in the translator... am I missing something and if not does someone have a work around. Thanks
1 REPLY 1
Laszlo Nagy
Community Admin
Community Admin
In the DWG/DXF Translator Dialog there is no setting that controls this.
The only thing I can think of is separate Layers.
You should place these dimensions for these different Partial Structure Display options on separate Layers in ArchiCAD.
Then in AutoCAD you will be able to display or hide then by turning their Layer On/OFF.
Loving Archicad since 1995 - Find Archicad Tips at x.com/laszlonagy
AMD Ryzen9 5900X CPU, 64 GB RAM 3600 MHz, Nvidia GTX 1060 6GB, 500 GB NVMe SSD
2x28" (2560x1440), Windows 10 PRO ENG, Ac20-Ac27