Collaboration with other software
About model and data exchange with 3rd party solutions: Revit, Solibri, dRofus, Bluebeam, structural analysis solutions, and IFC, BCF and DXF/DWG-based exchange, etc.

Wall coverings interrupted at corners

Anonymous
Not applicable
Hi - I have sucessful applied wall coverings to my building but one corner is not displaying properly on model view. It is perfect in plan view but there is a gap running up the building... I cant figure out how to fix this. (See image below)
1 REPLY 1
Anonymous
Not applicable
Have you tried opening the dbx for the covering & setting the cavity to zero
then in plan view un-mitre the corner using the red hot spot.
If I have got this incorrect please post the plan view.

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!