Hi, i always encounter this problem in the design process,
making wall recess don't always give a clean result in floor plan, i used several methods, using niches, column / beams with a higher material priority,
in this exemple i used a column,
is there a solution for that ?
Hi, do send 3D view of this wall n door area. Any plaster surface you are willing to show on as outer skin of wall?
Yes i'll need to add a thin plaster skin later
Here is à sketch, i’m not in office tokay
try this Option-1 :
Option-2 : Define new door with two unique ID's Wallhole & Wallniche.
Rather than SoE-ing, could you instead us a Wall Niche?